Glacier bay 67623W-6001 Guía De Uso Y Mantenimiento página 6

Installation (continued)
5
Adjusting the length of
horizontal rod
NOTE: If the horizontal rod of the drain assembly is too
long, do not cut, it can be adjusted.
□
If the horizontal rod (J) is too long, as shown
in Fig 1, the length can be adjusted.
□
Remove the clip (N) from the horizontal rod (J).
Slide the plastic portion of the rod to adjust to
the desired length. The excess length (1) can
be removed by snapping off with pliers at the
perforated segment, or cut off with a saw.
□
After the plastic portion is positioned properly,
reinstall the clip (N) as shown in Fig 3
J
J
K
J
Wall
Fig 1
1
N
Fig 2
N
Fig 3
6
Installing the lift rod
□
Slide the lift rod (O) through the faucet (A) until
the knob rests on the faucet (A).
□
Push the pivot rod (J) to the down position until
the stopper (D) is completely open. Press the
button (K) on the slip joint assembly (L) and
adjust the vertical rod (M) up or down and front
or back along the pivot rod (J) until the vertical
rod (M) is in the correct position to engage with
the lift rod (O). Press lift rod (O) into the top of the
vertical rod (M) until it engages.
□
Operate the lift rod (O) up and down to verify that
the stopper opens and closes correctly.
D
6
A
O
M
K
J
L
J
L
K