teutonia Soft tragetasche Manual De Instrucciones página 6

Soft Carrycot
Base plate external dimension: 735 mm x 282 mm
Suitable mattress dimensions: 30 cm width, 75 cm
length, 3,5 cm thickness
This soft carrycot corresponds to standard
EN 1466:2004-06
Fitting the fixed carrycot (accessories) into the
seat unit
1
1. Fit the supplementary restraint to the ring at the
lower end of the waist straps.
2. Place the carrycot into the seat unit and pull the
rubber strap over the footrest.
3. Guide the supplementary strap through the loop of
the carry cot and close the press studs.
Conversion to foot bag
6
3
The soft carrycot can be
used later as a foot muff
after a simple conver-
sion.
1. Open zip on base, re-
move base plate.
2. Remove all slot-in locks of the carrying harness and
pull out through the tunnelling
3. Remove head piece surround by opening the zip on
the head piece
Make sure that the narrow side of the base plate is
pushed in first.