Error Code Table; Technical Data - MIA IKP 2214 Manual De Instrucciones

Error code table

The error codes E0 to E03 may appear on the display and an audible warning signal may sound.
Error
E0
E01
E02
E03

Technical data

Mia type: IKP 2214 220-240V~ 50Hz, 3500W, protection class II
This appliance is GS-tested and complies with the CE directives.
Subject to technical modifications
Importer / Service address / Author
Prodomus Vertriebsgesellschaft mbH
Landsberger Straße 439
81241 München
GERMANY
© Copyright 2019 – Copyright notice
The content and layout of this manual are protected under copywright law.
Copying or reproducing this document for trade/commercial use is only permitted after
obtaining written consent from the author.
Possible cause and corrective action
Pot recognition: No pot on the hotplate or unsuitable cookware.
Place a suitable pot on the hotplate within 30 seconds.
Indicates a short-circuit in the electronics. Unplug the power cord
and wait a few minutes before attempting to restart the appliance. In
case of a defect, contact a qualified technician (*).
Temperature sensor defective. Unplug the power cord and allow the
appliance to cool down. If the appliance cannot be turned on again,
contact a qualified technician (*).
Electronic monitoring surge voltage protector has triggered. Check
whether the mains voltage of the wall socket which the appliance is
plugged into corresponds to the mains voltage indicated on the
rating plate.
22