Publicidad
Idiomas disponibles
Idiomas disponibles
Brake Disc Thickness Gauge, 0-35 mm
TECHNICAL DATA
Max. Measuring bracket opening:
Dimensions: 415 x 53 x 19.5 mm
Scale range: 0 – 35 mm
INTENDED USE
This product is used to measure the thickness of the brake disc.
ATTENTION
Read the operating instructions and the included safety information carefully before using the product.
Use the product correctly, with caution and only for the intended purpose.
Failure to observe the safety information can lead to damage, injury and voiding of the warranty.
Please keep these instructions in a safe and dry place for future reference.
Include the operating instructions if you pass the product on to third parties.
SAFETY INFORMATIONS
Note the information provided by the vehicle manufacturer, when checking the brake system.
Note the vehicle-specific service literature for technical data.
Keep children and unauthorized persons away from the work area.
Do not allow children to play with the tool or its packaging.
Make sure the work area is adequately lit.
Keep the work area clean, tidy, dry and free of other materials.
USE
1. Check the zero position before measuring.
2. Push the plastic ring (1) by hand to the largest
scale value.
3. Operate the handle until both probe heads (5 + 6)
are against each other.
4. When operating handle, the plastic ring (1) is
moved by push pin (3) on the scale and remains in
position when releasing the handle.
5. Check the position of the plastic ring (1). The
middle line on the plastic ring (1) should show the
scale value 0.
6. A difference to value 0, can be compensated by
screwing the probe head (5) in or out.
7. After setting, fix the probe head (5) with the lock
nut (4).
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
length 46 mm
depth 40 mm
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 70027
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
