Tripp-Lite NPOE-EXT-1G30 El Manual Del Propietario página 3

Single Extender Installation
1. Using a Cat5e/6 cable (up to 100 m / 328 ft. long), connect your
powered source device (such as a PoE switch) to the "IN" port on the
unit.
2. Using another Cat5e/6 cable (up to 100 m / 328 ft. long), connect
your remote PoE powered device (PD) (such as VoIP or IP surveillance
camera) to the "OUT" port on the unit. The LEDs will illuminate green for
power and orange for signal.
Note: Your PoE source must meet or exceed IEEE 802.3at / 802.3af standards.
Please see Maximum Supported Power table for more information.
Single Extender Installation Diagram
Single Extender Installation with Midspan Diagram
Note: Where external power is required, the power source (e.g.. midspan or PoE
injector) must be installed between the Ethernet switch (non-PoE source) and the first
NPOE-EXT-1G30WP extender.
18-12-182-9338FC.indb 3
PoE
Switch
Max 100 m (328 ft.)
Midspan
Switch
(Non-PoE)
Max 100 m (328 ft.)
PoE Extender
Max 100 m (328 ft.)
PoE Extender
Max 100 m (328 ft.)
3
Camera
Camera
2/12/2019 9:25:02 AM