Tripp-Lite NPOE-EXT-1G30 El Manual Del Propietario página 4

Multiple Extender Installation
Note: You may only cascade four PoE extender units up to 500 m (1640 ft.) in a
single installation.
1. Using a Cat5e/6 cable up to 100m long, connect your powered source
device (such as a PoE switch) to the "IN" port on the unit.
2. Using another Cat5e/6 cable (up to 100 m / 328 ft. long), connect the
"OUT" port of the first extender to the "IN" port of the second extender.
Note: The green LED will illuminate solid to indicate it is receiving sufficient power.
3. Repeat Step 2 up to two more times for each additional PoE extender
you wish to add or connect your remote PoE powered device (PD) to the
"OUT" port of the second PoE extender.
Notes:
• The 4th PoE extender will only supply IEEE 802.3af up to 12W.
• Your PoE source must meet or exceed IEEE 802.3at / 802.3af standards. Please
see Maximum Supported Power table for more information.
Multi-Extender Installation Diagram
PoE
Switch
Max 100 m (328 ft.)
18-12-182-9338FC.indb 4
PoE Extender
PoE Extender
Max 100 m (328 ft.)
PoE Extender
Max 100 m (328 ft.) Max 100 m (328 ft.)
4
Camera
2/12/2019 9:25:03 AM