Declaration Of Conformity; General Power Tool Safety Warnings - Hilti TE DRS­6-A Manual De Instrucciones

▶ Write down the serial number in the table below. You will be required to state the
product details when contacting Hilti Service or your local Hilti organization to inquire
about the product.
Product information
Dust removal module
Generation:
Serial no.:

1.4 Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with
the applicable directives and standards. A copy of the declaration of conformity can be
found at the end of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistraße 6 | 86916 Kaufering, DE
2 Safety

2.1 General power tool safety warnings

WARNING
Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
Work area safety
▶ Keep work area clean and well lit. Cluttered or dark areas invite accidents.
▶ Do not operate power tools in explosive atmospheres, such as in the presence
of flammable liquids, gases or dust. Power tools create sparks which may ignite the
dust or fumes.
▶ Keep children and bystanders away while operating a power tool. Distractions
can cause you to lose control.
Electrical safety
▶ Power tool plugs must match the outlet. Never modify the plug in any way. Do
not use any adapter plugs with earthed (grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of electric shock.
▶ Avoid body contact with earthed or grounded surfaces, such as pipes, radiators,
ranges and refrigerators. There is an increased risk of electric shock if your body is
earthed or grounded.
▶ Do not expose power tools to rain or wet conditions. Water entering a power tool
will increase the risk of electric shock.
▶ Do not abuse the cord. Never use the cord for carrying, pulling or unplugging
the power tool. Keep cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of electric shock.
▶ When operating a power tool outdoors, use an extension cord suitable for
outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
▶ If operating a power tool in a damp location is unavoidable, use a residual current
device (RCD) protected supply. Use of an RCD reduces the risk of electric shock.
Personal safety
▶ Stay alert, watch what you are doing and use common sense when operating a
power tool. Do not use a power tool while you are tired or under the influence of
10 English
Printed: 21.10.2016 | Doc-Nr: PUB / 5071244 / 000 / 04
TE DRS­6­A
02