Care And Maintenance - Hilti TE DRS­6-A Manual De Instrucciones

Ocultar thumbs Ver también para TE DRS­6-A:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
5.4 Setting drilling depth (depth gauge)
Note
If drilling depth has to be exact, drill test holes to establish the correct depth.
1. Press and hold down the button of the depth gauge.
2. Move the ring to the desired drilling depth.
3. Release the button of the depth gauge.
5.5 Emptying the dust container
Note
Dust can escape if the filter is full, so it has to be emptied regularly. Wear respiratory
protection when doing this.
1. Hold the power tool horizontal and allow it to run for a short time.
◁ This ensures that residual dust deposits in the dust removal module are drawn into
the dust container.
2. Press and hold down the release button of the dust container.
3. Pull the dust container down and clear of the dust removal module.
4. Empty the dust container.
5. Push the empty dust container back into the dust removal module from below until it
engages.
5.6 Removing the dust removal module
1. Set the forward / reverse selector switch on the rotary hammer drill to the middle
position.
2. Press and hold down the DRS release button.
3. Pull the dust removal module forward and clear of the power tool.
5.7 Changing the suction head
1. Remove the dust removal module from the rotary hammer drill.
2. Press and hold down the suction head release button.
3. Pull the old suction head up and out of its guide.
4. Press the new suction head into the guide until it engages.

6 Care and maintenance

6.1 Care and maintenance
▶ Check all parts of the module for signs of damage at regular intervals and make sure
that they all function correctly. Do not use the module if parts are damaged or if they
do not function correctly.
▶ Do not use water, oil, grease or cleaning products.
▶ Use only a dry brush and a cloth to clean the dust removal module.
▶ Do not touch the filter material when cleaning it and do not use compressed air to
clean it. This can damage the filter material.
14
English
Printed: 21.10.2016 | Doc-Nr: PUB / 5071244 / 000 / 04
4
5
6
7

Publicidad

Tabla de contenido
loading

Tabla de contenido