Care And Maintenance; Troubleshooting - Holiday Living & Design W11A0013 Manual Del Usuario

Replace the lamp.
Grasp plug and remove from receptacle or other outlet device. Do not unplug by pulling on the cord.

Pull bulb and plastic base out of lamp holder.

Replace bulb with only 2.5 volt, 0.5 watt super bright bulbs provided with the product.

If the new lamp base does not fit in lampholder, follow the steps below before step 3:
Remove the base of the burned out bulb by straightening the leads before pulling the bulb out.

Twist leads of the new bulb through the holes in the old base. Place one lead into each hole.

After the bulb is inserted into the holder, bend each lead upward so that the leads will touch the contacts inside the

lamp holder.

CARE AND MAINTENANCE

When product is placed on a live tree, keep the tree well-maintained, fresh, secure, and stable. Do not place on live

trees with needles that are brown or break easily. Keep tree holder filled with water.
Before using or reusing, inspect product carefully. Discard any products that have cut, damaged or frayed wire

insulation or cords, cracks in the bulb holders or enclosures, loose connections or exposed copper wire.
When storing product, remove product from tree to avoid undue strain or stress on conductors, connections and

wires.
Store neatly in a cool, dry location protected from sunlight.


TROUBLESHOOTING

PROBLEM
The product does not light.
A bulb is broken.
A bulb has burned out.
POSSIBLE CAUSE
1. One or more of the bulbs are
loose or out of the sockets.
1. The bulb was impacted or shifted
during transport.
1. Incorrect bulb or voltage is too
high.
CORRECTIVE ACTION
1. Unplug the product. Starting with the
first unlit bulb, gently push (don't
twist) each bulb firmly into the
socket. At the same time, look and
feel for a broken bulb in the socket or
an empty socket where a bulb has
fallen out.
1. Mark it with a piece of tape and
unplug the produce before removing
the bulb socket and any fragments.
Replace the broken bulb. Should a
light flicker while doing this, you
have probably found the faulty bulb.
Replace with a new bulb.
1. The remaining bulbs will stay lit;
however, it is best to replace any
burned out bulbs as soon as you find
them.
3