Replacing Battery - Uline MITUTOYO H-2781 Guia De Inicio Rapido

BATTERY-RELATED WARNINGS
WARNING! If the battery is misused or abused,
leaking or subject to extreme conditions,
explosion and/or fire can result. Observe the
following precautions to avoid instrument failure
or malfunction.
• Do not disassemble, deform, short-circuit, charge,
heat the battery to 212ºF or over or throw the battery
into a fire.
• Always insert the battery correctly according to the
polarities (+ and – ) marked on the battery and the
instrument.
• Always use the recommended battery.
• If the instrument will not be used for more than three
months, remove the battery and store it separately.
• When discarding or storing the battery, cover the
positive (+) and negative (–) terminals with insulating
tape to prevent contact with other metals. When
disposing of it, follow the ordinances or regulations
of the local government.
• Keep the battery away from direct sunlight, high
temperature, high humidity and out of the reach of
children.

REPLACING BATTERY

Use a silver oxide battery (SR44).
1. Remove the battery holder using a screwdriver.
2. Remove the spent battery.
3. Install a new battery into the battery holder with its
positive (+) side facing the front of the instrument.
4. Replace the battery holder into its original position.
IMPORTANT! A battery is not installed in this
instrument at the factory. Install the battery
before using.
• If the battery holder is not installed properly, the
instrument may not display the correct value or a
malfunction may result.
• If MEASUREMENT mode is not automatically entered
after executing the above procedure, reinstall the
battery.
PAGE 2 OF 12
SAFETY CONTINUED
• Do not swallow the battery. If swallowed, consult a
physician immediately.
• Should the content of the battery contact the
eyes or skin, or enter the mouth, rinse with water
immediately and consult a physician. Should it
adhere to clothing, wash the clothing with water.
DISPOSAL WARNINGS
• The liquid crystal display contains an irritating
substance. Should the liquid content contact the
eyes or skin, or enter the mouth, consult a physician
immediately.
• Do not disassemble or modify.
• Do not use an electric engraving pen or other such
devices on the instrument. It may cause damage.
SETUP
• When the battery is installed, nonsensical numbers
or an "E" may be displayed on the readout. This is
not a malfunction. Zero the instrument, then perform
the measurement.
• If the instrument will not be used for more than three
months, remove the battery and store it separately
to prevent damage by battery leakage.
• The supplied battery is used only to check the
functions and performance of the instrument.
It may not meet the battery life specification.
• If the battery is removed, zeroing is cancelled.
After installing the battery, perform the steps to zero
the instrument.
WARNING! A liquid crystal display and a
silver oxide battery are used in this product.
When disposing of the instrument, follow
the ordinances and regulations of the local
government.
IMPORTANT! Do not strike the instrument or
allow it to be struck. Do not drop or apply
excessive force to it.
NOTE: Do not use a sharp-pointed tool to
remove the battery holder and do not pry the
battery holder out.
0421 IH-2781