Black and Decker HT18 Manual De Instrucciones página 6

3. TRIMMING NEW GROWTH - (figure
G) – A wide, sweeping motion, feeding
the blade teeth through the twigs is
most effective. A slight downward tilt
of the blade, in the direction of motion
gives the best cutting.
caUtioN:
Do not use model Ht18
trimmer for cutting stems greater than 5/8
in. (16mm). Do not use models Ht20,
Ht22 trimmers for cutting stems greater than 3/4 in. (19mm). Use
the trimmer only for cutting normal shrubbery found around houses
and buildings.
4. LEVEL HEDGES (figure H) – To
obtain exceptionally level hedges, a
piece of string can be stretched along
the length of the hedge as a guide.
5. SIDE-TRIMMING HEDGES (figure
i) – Begin at the bottom and sweep up.
All manuals and user guides at all-guides.com
G
0- 15
H
I
6
WarNiNG:
TO GUARD AGAINST INJURY, OBSERVE THE
FOLLOWING:
• READ INSTRUCTION MANUAL BEFORE USING, SAVE
INSTRUCTION MANUAL.
• CHECk THE HEDGE FOR FOREIGN OBJECTS SUCH AS
WIRE OR FENCES BEFORE EACH USE.
• kEEP HANDS ON HANDLES. DON'T OVERREACH.
• DO NOT USE UNDER WET CONDITIONS.
• DO NOT USE WITH DAMAGED EXTENSION CORD.
DANGER:
KEEP HaNDs aWay froM blaDEs.
caUtioN:
blaDE coasts aftEr tUrN off.
MaiNtENaNcE
WarNiNG:
Remove extension cord from trimmer before servicing,
cleaning or removing material from the gardening appliance.
The cutting blades are made from high quality, hardened steel and
with normal usage, they will not require resharpening. However, if you
accidentally hit a wire fence (figure J), stones, glass
or other hard objects, you may put a nick in the blade.
There is no need to remove this nick as long as it does
not interfere with the movement of the blade. If it does
interfere, unplug the cord and use a fine toothed file
or sharpening stone to remove the nick. If you drop
the trimmer, carefully inspect it for damage. If the
blade is bent, housing cracked, or handles broken
or if you see any other condition that may affect the
trimmer's operation contact your local Black+Decker
Service Center for repairs before putting it back into
use. Fertilizers and other garden chemicals contain
agents which greatly accelerate the corrosion of
metals. Do not store the unit on or adjacent to fertilizers or chemicals.
Use only mild soap and a damp cloth to clean the unit. Never let any liquid
get inside the unit; never immerse any part of the unit into a liquid. Prevent
the blades from rusting by applying a film of light machine oil after cleaning.
J