Replace The Filter - Mi 3C Manual Del Usuario

Replace the Filter

Make sure to turn off the air purifier and disconnect power before replacing the filter.
Note: To avoid injuries, do not stick your fingers in between the top and the bottom part when opening or installing the filter
compartment.
Opening the filter compartment
1
Press and hold the buttons (as in
the figure) to remove the top part of
the purifier in order to open the filter
compartment.
Resetting the filter
4
When the air purifier is in
standby mode, press and hold
the Power/Mode button for six
seconds until the air quality
indicator lights up in green for
one second. Once you hear
three beeps, the filter has been
reset successfully.
Note: It is recommended to replace the filter every 6–12 months.
When the filter needs to be replaced, the indicator light will blink red
once the purifier is turned on. To ensure your purifier properly works
and purifies, please visit www.mi.com to purchase a genuine Mi filter.
Removing the filter
2
Remove the old filter.
4
Installing the filter
3
Insert the filter from the top in order
to install it in the correct position,
and install the top part of the purifier
onto the filter compartment.
Resetting Wi-Fi
5
If your phone is unable to connect with the
purifier, simultaneously press and hold the
Power/Mode and the Display/Wi-Fi Reset buttons
for five seconds. Once you hear a beep, the Wi-Fi
connection has been reset successfully.