Troubleshooting - DeLonghi EMFI Manual De Instrucciones

DESCRIPTION (page 3)
1. Lid
2. Hot/frothed milk accessory
3. Whisk
4. Milk container
5. Milk container handle
6. ON/OFF/function button:
Hot frothed
milk
Hot milk (not
frothed)
Cold frothed
milk
7. Base with electrical connector
8. Power cord

TROUBLESHOOTING

Problem
The appliance does not come on
There is little or no froth on the milk
The milk overflows.
The blue LED flashes
Press once
(fig. 6)
red LED
Press twice
(fig. 7)
flashing red LED
press and
hold for a few
blue LED seconds (fig. 8)
Cause
It is not plugged into the mains socket.
The appliance has a safety device which
imposes a 30 second pause between one
preparation and the next.
The "Hot milk (not frothed)" function is
selected.
The milk is too hot.
After cleaning, the whisk (3) has not
been replaced in the hot/frothed milk ac-
cessory, or the whole accessory is absent
or incorrectly positioned.
Too much milk has been placed in the
container.
The appliance is standing on a sloping
surface.
The appliance has been operated without
milk.
Please note:
Preparation can be interrupted at any moment by simply lifting
the milk container from the base or pressing the
once.
Solution
Plug into the mains.
Wait, then select the required function.
Prepare the milk again, using milk at
refrigerator temperature and pressing
the function button once (red LED on
steadily).
Use milk at refrigerator temperature.
Insert the whisk in the accessory and
make sure the accessory is correctly po-
sitioned in the appliance.
Always respect the MAX quantity indica-
ted for each preparation.
The appliance must always be operated
on a flat surface.
Remove the appliance from the base.
Wait until it cools down. To cool it
down faster, pour milk at refrigerator
temperature into the container.
11
button