Krups EXPERT S9900 Manual De Instrucciones página 21

The appliance will not start if the cover (b2) or (a8) is not latched shut.
Before using for the first time, clean all parts of the accessories according to the instructions in the section
CLEANING.
For using a dishwasher, refer to the section CLEANING.
Place the appliance on a flat, clean and dry surface and then plug in your appliance.
n It can be started in a number of ways:
peatedly for better control of the preparation process.
depending on the food you are preparing. You can change the setting during preparation.
To "boost" certain preparations. Turn the speed control knob (a1) to position 12, and give a
pulse on the button (a13) to increase the speed. To return to speed 12, press this button once again.
Turn the speed control knob (a1) back to 0 setting.
n This function enables you to:
1/ Measure the operating time: the seconds counter will start to run on the display (a11) as soon as
you turn the speed control (a1), enabling you to measure the time required to obtain the required re-
sult.
2/ Programme an operating time up to 16 minutes. To this end:
Once the appliance is ready to start, press the
decrease it (a12).
- For longer times: hold down the button pressed and the setting will change more quickly.
- For shorter times or fine adjustment: press the
- To jump directly from the maximum time of 16 minutes to zero: hold down the
onds.
- To jump directly from zero to the maximum time of 16 minutes, hold down the
onds.
- To cancel a time setting: press the
As soon as you turn the speed control knob (a1), the display will show the time counting down and the
appliance will stop after the programmed time has elapsed.
The appliance can also be stopped at any time by turning the speed control knob (a1) back to 0.
n
n
Turn the speed control knob (a1) to the "pulse" position (a2) re-
Turn the speed control knob (a1) to the desired setting from "1" to "12"
button and
button to increase the setting or
button briefly several times
button together.
button to
button for 2 sec-
button for 2 sec-