REV Ritter 93258 Manual De Operación Y Mantenimiento página 7

TECHnICAL DATA
• Voltage:
• Illuminant:
• Luminous flux:
• Colour temperature:
• Protection class:
InSTALLInG THE TRIPOD (see 1)
• Attach the floodlight to the tripod using the centre hole of the housing
bracket and the supplied bolt.
Setting the Floodlight direction
• Loosen the screws on the sides underneath the housing and adjust the
floodlight direction and then retighten all screws.
The floodlight is now ready for use and can be operated under the intended
conditions – it is essential that the requirements specified under "General
Safety Instructions" in regards to the installation location are followed.
CLEAnInG
• Before cleaning the LED floodlight, disconnect the power cable and allow
the floodlight to cool down sufficiently.
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent
if required. Do not use cleaners that contain abrasives or solvents.
MAInTEnAnCE
• Check the plug, power cable, and housing of the LED floodlight for damage
before each use. If the lens is damaged it must be replaced immediately.
• Clean any dirt from the housing or the lens immediately, since it could
cause overheating.
230V~, 50Hz
20W LED Chip
approx. 1400lm
6500K
IP44
GB
7