Robot AXG-Y1 Guia Del Usuario página 3

Brazil Radio:
For more information, see the ANATEL website www.anatel.gov.br
This equipment is not entitled to protection against harmful interference and must not
cause interference in duly authorized systems.
This product contains the AXG‐Y1 board Anatel approval code XXXXX‐XX‐XXXXX
Mexico Radio:
Contains Module IFETEL ID: XXXXXXXXX‐XXXX
For use in Mexico, the operation of this equipment is subject to the following two
conditions:
(1) this equipment or device may not cause harmful interference and
(2) this equipment or device must accept any interference, including interference
that may cause undesired operation.
Argentina Radio
Module Certification: Contains Module CNC ID: C‐XXXXX
Antenna Installation
1. The antenna must be installed such that 20cm is maintained between the antenna
and users,
2. The transmitter module may not be co‐located with any other transmitter or
antenna,
3. Only antennas of the same type and with equal or less gains as shown below may be
used with this module. Other types of antenna and/or higher gain antennas will
require additional authorization for operation.
In the event that these conditions cannot be met, then the FCC/IC authorization is no
longer considered valid and the FCC ID/IC ID cannot be used on the host device. In
these circumstances, the OEM integrator will be responsible for re‐evaluating the host
device (end‐product), including the transmitter and obtaining a separate FCC/IC
authorization.
iRobot.com iRobot Corporation | 8 Crosby Drive, Bedford MA 01730 | 781.430.3000