Robot AXG-Y1 Guia Del Usuario página 5

o Consult the dealer or an experienced radio/TV technician for help.
 FCC Radiation Exposure Statement: This product complies with FCC §2.1091(b) for mobile device
RF exposure limits, set forth for an uncontrolled environment and is safe for the intended
operation as described in this manual. To ensure compliance with FCC and ISED RF exposure
requirements this device must be installed to provide a minimum of 20cm between the device
and people.
iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730, USA
www.irobot.com
http://global.irobot.com
6.2 Canada – Innovation, Science and Economic Development (ISED)
This device contains a licence‐exempt transmitter/receiver that complies with Innovation,
Science and Economic Development Canada's licence‐exempt RSS(s). Operation is subject to
the following two conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
 Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than the necessary for successful communication.
 ISED Statement on Radiation Exposure: This product is compliant with the Canadian
Standard IC RSS‐102, Restriction of RF Exposure in an Uncontrolled Environment. The
device can be used safely for its intended purpose, as described in this manual. Per ISED
requirements, maintain a distance of more than 8 inches (20cm) between any person and
the Roomba robot.
French Text:
Cet appareil respecte l'alinéa 15 de la réglementation FCC. L'utilisation doit respecter les deux
conditions suivantes :
(1) cet appareil ne doit pas provoquer d'interférences nuisibles, et
(2) cet appareil doit tolérer toute interférence reçue, y compris les interférences
susceptibles d'engendrer un fonctionnement indésirable.
• Cet appareil est conforme aux normes d'exemption de licence RSS d'Industry Canada.
L'utilisation doit respecter les deux conditions suivantes : (1) cet appareil ne doit pas
provoquer d'interférences, et (2) cet appareil doit tolérer toute interférence, y compris
les interférences susceptibles d'engendrer un fonctionnement indésirable de l'appareil.
• Les changements ou modifications non approuvés expressément par iRobot Corporation
sont susceptibles d'entraîner la révocation de l'autorisation d'utilisation de l'appareil. Cet
iRobot.com iRobot Corporation | 8 Crosby Drive, Bedford MA 01730 | 781.430.3000