DynaTrap DT1000-12V El Manual Del Propietario

OWNER'S MANUAL
FLYING INSECT TRAP
MODEL: DT1000-12V
FOR INDOOR/OUTDOOR USE
Thank you for purchasing the
DYNATRAP flying insect trap!
®
IMPORTANT SAFETY INSTRUCTIONS
WARNING, When using electric appliances, basic precautions should always be followed, including the following:
– To disconnect, turn all controls to the off ("O") position, then remove plug from outlet.
– Unplug from outlet when not in use and before servicing or cleaning.
– To reduce the risk of electrical shock, do not put appliance in water or other liquid.
– This appliance is provided with double insulation. Use only identical replacement parts.
– Connect only to a circuit that is protected by a ground-fault circuit-interrupter (GFCI).
See instructions for Servicing of Double-Insulated Appliances.
INSTRUCTIONS FOR DOUBLE-INSULATED, CORD-CONNECTED APPLIANCES:
In a double-insulated appliance, two systems of insulation are provided instead of grounding. No grounding means is provided
on a double-insulated appliance, nor should a means for grounding be added to the appliance. Servicing of a double-insulated
appliance requires extreme care and knowledge of the system, and should be done only by qualified service personnel.
Replacement parts for a double-insulated appliance must be identical to those parts in the appliance.
IMPORTANT SAFETY INSTRUCTIONS
Please read these instructions before using the DYNATRAP ® Mosquito Trap and keep for future reference.
1. Always turn unit off and disconnect plug before servicing, cleaning, or changing bulb.
2. Do not position the unit near heat, gas, oil or other flammable materials.
3. Place product out of reach from children.
4. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or
damaged, or if it has been dropped into water.
5. This product is equipped with 2-conductor cord and 2-prong polarized plug as a safety feature. This plug will fit in a
polarized outlet only one way. If the plug does not fully fit in the outlet, then reverse the plug. If it still does not fit,
then contact a qualified electrician. To reduce the risk of electrical shock, only plug into a properly installed outlet.
Do not attempt to defeat this safety feature.
6. Do not insert fingers or any foreign objects into the unit while it is connected to an electrical outlet.
7. Collected insects within the unit may contribute to fire, so clean insects from the unit frequently.
8. Do not clean this product with water spray. Do not place where it can fall into water, or near flammable materials.
9. Do not touch fan while in motion.
10. Do not abuse cord—never carry or hang unit by cord or yank it to disconnect from receptacle. Keep cord away from heat,
oil, or sharp edges.
11. Extension cords used with this product must be marked with suffix letters "W-A" and with a tag stating "Suitable for Use
with Outdoor Appliances".
12. Use only extension cords that have plug and receptacles that match the product plug. Replace or repair damaged cords.
INSTALLATION & OPERATING INSTRUCTIONS
1. Unpack Unit. Save carton for off-season storage (if needed).
2. If hanging the unit, place approximately 3–6 feet above floor/ground level for optimal catch rate and easy access for cleaning.
3. Plug cord into an outdoor outlet or UL listed extension cord as described in "IMPORTANT SAFETY INSTRUCTIONS".
4. For best catch results leave unit on at all times, except when cleaning or servicing.
5. Catch rate activity will be higher at night. For best catch results it is recommended to place unit away from other competing
light sources. Intended for household use only.
6. It is recommended to place the unit at least 10 to 20 feet away from where people will be sitting.
7. This unit is all-weather resistant - designed for outdoor use including rainy conditions.
CLEANING
Frequent cleaning will prolong the life of the unit, ensure fire prevention and
provide for more efficient operation.
1. Be sure to clean the unit once per week.
2. Switch the unit off and unplug before cleaning.
3. For weekly cleaning, remove the cage by turning it clockwise. Remove any
buildup from the inside of the retaining cage and fan with a brush (included).
4. For major cleaning, press and separate middle body as described below in
"Replacing Bulbs." (recommended once a year after peak season).
5. When replacing retaining cage, DO NOT press or hold onto screen windows. Should the
screen detach from the frame, re-align the screen into the track within the frame.
REPLACING BULB
The light bulb life expectancy is approximately 3,000 hours (or about 4 months), and should be
replaced regularly to ensure optimal UV effectiveness. Even though the bulb's light may be visible
to you, its ability to attract insects diminishes over time.
1. Turn power switch to "off" position. UNPLUG UNIT, and allow bulb to cool before replacing.
2. Remove retaining cage, and turn unit upside down.
3. Separate the middle body from the upper body. Some force may be required to separate the pieces.
4. Carefully pull the bulb from the socket and replace with a new one. (NOTE: Bulb may be held in
place by a metal bracket for shipping. Unscrew and remove metal bracket to remove the bulb.
The bracket is not necessary and may be discarded.)
5. After bulb has been replaced, re-attach middle body to upper body. Make certain that the middle
body snaps into place and that fan wires are not pinched.
Replacement Fluorescent Bulbs can be found at your local retailer or can be ordered directly from
www.dynatrap.com
HOW THE DYNATRAP
®
INSECT TRAP WORKS
Flying insects are attracted to the unit by UV light
and CO that is generated by the photo-catalysis
2
between the UV lamps and special TiO coating.
2
The fan then pulls the insects into the screened
base, trapping them until they dehydrate and die.
The base can be removed, allowing the contents
to be periodically emptied into the trash. The
see-through screen shows the insects trapped in the FAN
compartment, alerting you when the net needs to
be emptied.
RETAINING
CAGE
TROUBLESHOOTING
Problem:
Bulb does not illuminate
and fan does not spin.
Bulb illuminates, but fan
does not spin.
Fan spins, but bulb does
not illuminate.
LIMITED WARRANTY
warranties to the original purchaser that this product is free from defective materials and
workmanship. This warranty is limited to remedy any defective part for a period of one year from date of
original date of purchase. Retain your original receipt as proof of purchase. This warranty does not apply
to the light bulb, nor to, in our judgment, misuse or abuse. If this unit has been altered, no warranty is in
force. This warranty does not apply if this unit is purchased outside the United States, Canada and Mexico.
In no case shall
of any kind for breach of this or any other warranty, expressed or implied, whatsoever. Some states do
not allow limitation on how long an implied warranty lasts, so the above limitation or exclusion may not
apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary
from state to state.
PARTS & ACCESSORIES AVAILABLE
PART DESCRIPTION
41050 7-Watt Replacement Fluorescent Bulb (1 piece)
31052-12V Fan Blade and DC Motor Ultra-Long Life Replacement
by visiting
Dynamic Solutions Worldwide, LLC
12247 W. Fairview Ave. Milwaukee, WI 53226
hANGER
Phone: 414-431-2819
ON/OFF SWITCh
Toll free: 1-877-403-TRAP (8727)
UV BULB Toll free fax: 877-403-3293
Email: dynatrapinfo@dsw-llc.com
Visit us online at www.dynatrap.com
© DSW-LLC
TiO COATED
2
SURFACE
SAVE THESE INSTRUCTIONS
AUTOMATIC DAMPER
CLOSES WhEN TURNED
OFF, PREVENTING
LIVE INSECTS FROM
ESCAPING
Possible cause: Correction:
1. No electrical power. 1. Check plug and receptacle and fuse or circuit breaker.
2. Check to make sure power is switched to the "on" position.
1. Shorted fan. 1. UNPLUG UNIT: Examine fan to see that it is free from
foreign material, dirt or build-up of dead insects. Clean unit as
in "CLEANING" section.
1. Bulb not seated 1. Check all sockets for proper bulb seating and alignment.
properly. 2. Replace bulb if needed following instructions under
2. Burnt out bulb. "Replacing Bulb".
be liable for any accidental, punitive, consequential, or any other damages