Connect The Wiring; Install The Filters - KENMORE ELITE 51293 Manual De Uso Y Cuidado / Instalacion

WARNING: Risk of electric shock. Electrical
wiring must be done by qualifi ed personnel
in accordance with all applicable codes and
standards. Before connecting wires, switch
power off at service panel and lock service
disconnecting means to prevent power from
being switched on accidentally.
1. Connect House Power Cable to range hood wiring:
BLACK to BLACK, WHITE to WHITE and GREEN or
bare wire under GREEN ground screw.
2. Reinstall the blower cover plate (shaded part on
illustration beside) using the lock nut and 7 screws
previously removed in steps 3 and 6 on page 8. Pay
attention to screw 1 location; from back of hood point
of view, it must be located on left side of the lock nut
(see inset).
3. Reinstall the fi llers by following steps as illustrated
beside.
Ducted Installation Only:
Re-install grease fi lters removed in step 1 on page 7,
under "Prepare the Hood".

CONNECT THE WIRING

INSTALL THE FILTERS

Non-ducted Installation Only:
Purchase two non-ducted fi lters (see part number in
Service parts list). Attach the non-ducted fi lters following
instructions packed with the non-ducted fi lters.
"Non-ducted Filters" available by calling Sears at
16
HOUSE
POWER
CABLE
5 4
6
1
7
BACK OF HOOD
1
LOCK NUT
1-800-4-MY-HOME
MOTORS
GROUND
WIRE
GROUND
SCREW
3
2
®