Bond HYUTT33001-1 El Manual Del Propietario página 9

OPERATION
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the "off"
position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles
occur on any connection there may be a leak. If you smell gas or a leak is discovered turn the
gas valve off, disconnect propane gas tank and do not use the appliance until the leak is
repaired.
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion
you must replace the hose (if applicable). Pumice stones/lava rocks/LavaGlass could pop up and
20 minutes after igniting. Flame height should be a yellow/blue color between 2 - 10 inches in
height.
Wait 50 minutes after extinguishing ame prior to placing a lid (if applicable) or protective cover on
heating item.
To Light
1. Turn control knob (H) to the "OFF" position. Connect propane gas tank to regulator
and open the cylinder valve.
2.
Push and turn the control knob (H) counter-clockwise to 'HI', then use a match or a lighter to
light the firebowl. Once lit , keep holding down the control knob for 15 seconds.
3 .
To adjust the flame, turn the control knob (H).
To Extinguish
1. Push and turn the control knob (H) clockwise to the "OFF" position.
2. Turn the propane gas tank valve on the gas tank to close the gas supply and disconnect
the propane gas tank.
WARNING
Fire product and propane gas cylinder minimum
distance must be over 60 inches (as per right side
photo).
®
1-866-771-2663 | Page 9