Connecting The Touch Module - BenQ RP790 Manual De Instrucciones

Connecting the multimedia inputs
To view multimedia files on the USB flash drive:
1. Plug the USB flash
When the users insert the USB flash drive, a notice will be popped up, which would
2.
lead the users to the Multi-media mode. Please go to page 33 for more details.
flash
USB drive

Connecting the touch module

Connect the USB TYPE A FOR TOUCH (type A) jack (TOUCH 1, TOUCH 2) on the
display to the USB port of a computer using the supplied USB cable.
The touch module of the display supports easy Plug-and-Play operation. There is no need
to install additional drivers on the computer.
• Avoid blocking the touch screen frame (where sensors are located) when initiating the touch
module.
• It is highly recommended that you connect the display to the PC or laptop directly. Avoid
connecting the display to a face plate device which may cause failures in touch operations.
• If any ghost image occurs, please try to un-plug and then re-plug all USB cables. If the failure image
still exists, use another USB type A to A cable.
• TOUCH USB-1 must be used with HDMI 1 or TOUCH USB-2 must be used with HDMI 2,
HDMI 3, HDMI 4, HDMI 5 or VGA.
M USB port.
drive in the
Connection
USB cable
Computer
17