Cafe CCP06DP Serie Manual Del Propietario E Instrucciones De Instalación página 13

Installation Instructions
INSTALLING THE WINE CENTER (Cont.)
REVERSING THE DOOR SWING - MODELS WITH POCKET HANDLE - CCR06DM**** (Cont.)
2. Peel back the gasket and remove it from the door.
Gasket
3. Use a flat screwdriver to remove the plastic covers
near the top and bottom hinge.
4. Loosen the screws that hold the top and bottom
hinges to cabinet.
Screws
5. Remove the door and close the hinges.
WARNING
While closing the hinge, keep fingers away from the
internal moving parts of the hinge.
6. Remove the hinge screws
and install them on the other
side. Install screws only part
of the way so that hinges
can slide behind the screw
heads.
49-1000492 Rev. 3
Door Hinge Pinch Point
Hazard
Screws
7. Remove trim screws and install in opposite corners.
Trim Screws
8. Remove the hinges by fully loosening (2) screws.
9. Use a flat screw driver to remove the top and
bottom door trim.
10. Re-install hinges and door trim in opposite locations
as shown in the images below.
1
3
4
2
11. Open the hinges. Install door by sliding the hinges
behind the screw heads. Tighten screws.
12. Re-install all remaining cabinet and door trims.
Re-install the gasket. Make sure that the gasket is
fully seated in the pocket.
2
4
3
1
13