Whirlpool DU1050XTPQ0 Manual Del Usuario página 3

12. Remove the T-15 Torx screw securing the soil sensor
and remove the soil sensor. It may be necessary to
remove the drain hose first in order to access the
screw.
REMOVE
SCREW
13. Take note of the various shields attached to the wash
motor assembly and be sure to return them to their
proper locations during re-assembly.
14. Remove the drain pump by depressing the locking tab
and running the drain pump counterclockwise.
LOCKING
TAB
15. Remove the three sump locking tabs by pulling them
out of the sump.
NOTE: If the dishwasher is on it's back, set it upright.
SUMP
TAB
16. Push upward on the front of the wash-motor assembly
from underneath the sump assembly.
17. Open the dishwasher door.
18. Pull the wash-motor assembly forward slightly and lift
it out of the dishwasher tub.
19. Disconnect the wash motor wiring connector by
depressing the tabs on either side of the connector
and pull it out of the motor connector.
20. Remove and scrap the old wash motor assembly. To
21. Install the NEW wash-motor assembly by first
22. Locate the sump into the tub opening with the locator
23. Reverse the procedure to reassemble the dishwasher,
24. Plug in the dishwasher or connect the power.
25. Run a short cycle and check for leaks and for proper
SUMP
TAB
PUSH UPWARD ON
THE FRONT OF THE
WASH MOTOR
ASSEMBLY
26. Install Blue label supplied with kit just below the model
27. Explain the repair procedure to the customer by
28. Record all customer information, including model,
DEPRESS TABS ON
BOTH SIDES
properly scrap the old motor (prevent it from being
reused), cut the wires going to the harness connector
as illustrated in the picture below. Dispose of the
motor.
CUT THESE 3 WIRES
WITH DIAGONAL
lubricating the sump gasket with rinse aid.
tab aligned with the slot in the tub.
making sure that all the motor shields are reinstalled
properly.
operation.
INSERT
BLUE LABEL
ON
TANK JUST BELOW
MODEL
SERIAL TAG.
/ serial tag on the inside of the tank.
covering the content of "leave behind" material included
in kit.
serial number and the date of purchase for the
dishwasher. Report all this information back to
Whirlpool through the service claim process using
Rework Code #R14165.
CUTTERS
LUBRICATE
SUMP SEAL
WITH RINSE AID
LOCATOR
TAB