Metra AX-TOYCAM3 Instrucciones De Instalación

Installation Instructions for AX-TOYCAM3
Toyota Back-Up Camera Retain/Add-On
• Retains the factory back-up camera to an aftermarket radio
• Allows an aftermarket camera to be added to the OEM screen
• Provides 6-volt output for the factory back-up camera
toyota
4-Runner
• Connectors (example: butt connectors, bell caps, etc.)
Caution: Metra recommends disconnecting the negative battery terminal before beginning any
installation. All accessories, switches, and especially air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
• Connect the yellow wire to accessory power.
• Connect the Black wire to chassis ground.
the aX-toycam3 can be connected two different ways
to retain the factory back-up camera to an aftermarket radio:
• Connect the male yellow RCA jack to the rear camera input of the aftermarket radio.
• Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle.
to allow an aftermarket camera to be added to the oem screen:
• Connect the female yellow RCA jack to the new aftermarket camera.
1-800-221-0932
REV. 6/1/15
AX-TOYCAM3
2014
Features
interFace components
• AX-TOYCAM3 harness
appLications
Camry
2014 Corolla
toooLs reQuireD
• Cutting Tool • Tape • Crimping Tool
Connections to be made
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
2014 Highlander
2014 Sequoia
metraonline.com
2014
2014