Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Installation instructions for part AXGM-13
GM Data Interface
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake,
reverse, speed sense)
• Retains chimes
• Pre-wired AXSWC harness
(AXSWC sold separately)
• AXGM-13 interface • AXGM-13 harness
• 16-pin harness with stripped leads
CADILLAC
STS
Axxess Integrate
AXGM-13
2005-2011
INTERFACE FEATURES
• Retains OnStar / OE Bluetooth
• Adjustable OnStar level
• Designed for amplified models
• Retains balance and fade
• AXUSB-CBL (sold separately) updatable
INTERFACE COMPONENTS
APPLICATIONS
2005-2011
axxessinterfaces.com
Connections to be made .........................................2
Installing the AXGM-13 ..........................................3
Initializing the AXGM-13 ........................................3
Adjusting the AXGM-13 ..........................................3
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
• Small flat-blade screwdriver
CAUTION!
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
metraonline.com
Table of Contents
All accessories, switches, climate controls panels, and
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION

Publicidad

Capítulos

Tabla de contenido
loading

Resumen de contenidos para Axxess AXGM-13

  • Página 1 • AXUSB-CBL (sold separately) updatable • Small flat-blade screwdriver • Pre-wired AXSWC harness (AXSWC sold separately) INTERFACE COMPONENTS • AXGM-13 interface • AXGM-13 harness • 16-pin harness with stripped leads APPLICATIONS CAUTION! All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling CADILLAC the ignition.
  • Página 2: Connections To Be Made

    Note: If installing an AXSWC (sold separately), there will be an accessory wire there to connect as well. From the AXGM-13 harness to the aftermarket radio: • Connect the Blue/White wire to the amp turn on wire. This wire must be •...
  • Página 3: Installing The Axgm-13

    • Connect the AXGM-13 harness to the wiring harness in the vehicle. raise the audio level; counterclockwise to lower the audio level. Note: If using the AXSWC, connect it after you initialize and test the AXGM-13, • Once at a desired level, audio level adjustment is complete.
  • Página 4: Important

    Installation instructions for part AXGM-13 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated.
  • Página 5 Instrucciones de instalación para la pieza AXGM-13 Indice AXGM-13 Interfase de Datos GM Conexiones que se deben hacer ......2 Instalación del AXGM-13 ........3 2005-2011 Inicialización del AXGM-13 ........3 Ajuste del AXGM-13 ..........3 CARACTERÍSTICAS DE LA INTERFASE • Provee corriente de accesorios (12 voltios •...
  • Página 6: Conexiones Que Se Deben Hacer

    • Conecte el cable azul/blanco con el cable de encendido del amplificador. Este Del arnés AXGM-13 al radio de mercado secundario: cable debe estar conectado para escuchar sonido del amplificador de fábrica. • Conecte el cable negro al cable de tierra.
  • Página 7: Instalación Del Axgm-13

    Con la llave en la posición de apagado: Ajuste del nivel de audio: • Conecte el arnés de 16 pins con conectores pelados, y el arnés AXGM-13, a la • Con el vehículo y el radio encendidos, aumente el volumen hasta 3/4 de su totalidad .
  • Página 8: Importante

    Instrucciones de instalación para la pieza AXGM-13 IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente...

Tabla de contenido