Axxess TYTO-02 Manual De Instrucciones página 3

Installing the TYTO-02
• With all connections completed to the aftermarket radio, plug the 28- and
10-pin harness into the vehicles wiring harness.
• Reconnect the negative battery terminal.
• Cycle the key, by turning the ignition on for 30-seconds. Then off and on again
to test the radio.
Testing the TYTO-02
• Turn the ignition on if not already, and then turn the radio on to verify that the
radio works. Check balance and fader controls for proper operation.
• To adjust the overall volume of your audio system, rotate the potentiometer
which is located on the 12-pin side of the interface clockwise.
additional 12 pin harness (aSWC-1 harness)
This 12-pin harness is to be used in conjunction with the ASWC-1 (not included).
Please refer to ASWC-1 instructions for programming.
TYTO-02
3
Notes