Installation - Connection - Unitek UNISOLAR 10.24S Manual De Instrucciones

INSTALLATION - CONNECTION

Connect each component to the symbols added next to each relay (cables not included).
Please follow the connection order in accordance with the polarities.
In case of non-compliance, your solar charge controller as well as your battery may be damaged.

Connect your battery to the solar charge controller (+ and -)
Battery indicator lights on.

Select your battery technology:
- Press and hold the switch for 5 seconds, the active light flickers
- Select your battery's technology by pressing the button
Liquid:
Gel :
AGM:
- To confirm your selection, wait for 5 secondes. The light becomes
fixed again. Unisolar memorises your last setup.

Connect your photovoltaic panel to the solar charge controller (+ and -)
In case of disconnection, follow the opposite order.
NB : Grounding of the solar charge controller is not necessary. If you do want ground your installation, always do
it on the positive cables.
Open lead/acid liquid battery
Gel battery
Lead battery (maintenance-free), AGM...
www.uniteck.fr
EN
19/40