Fast Ethernet Rackmount PoE Switch • User Manual
Thank you for purchasing the INTELLINET NETWORK SOLUTIONS
Fast Ethernet Rackmount PoE Switch, Model 503631 (15.4 Watts/port) or
Model 524155 (7.3 Watts/port).
Connections
The 16 RJ45 connections on the front panel (partially shown below) match
workstations, servers or other network devices to 10/100 Mbps switching
ports that automatically negotiate full/half duplex mode, allowing you to
connect the switch to 10Base-T and 100Base-TX devices. NOTE: the 16 ports
also provide a 48 V power-injector PSE (power source equipment) function.
LINK/ACT
LINK/ACT
POWER
Power switch — The AC power outlet and switch are on the rear panel.
PCs, servers and other devices — Use Cat5 straight-through twisted-pair cables
to configure a network.
Hubs and other switches — Use either straight-through or crossover cable to
connect to the uplink port of a hub or another switch: This device supports
Auto-MDIX on all ports.
Powered devices — Use Cat5 twisted-pair cable to supply 48 V to a powered
device connected to any of the 16 ports. NOTE: Any connected devices should
also be IEEE 802.3af compliant.
LEDs
Power — When lit, there is power to the switch.
Poe — When lit, the port is linked to a PoE device.
LINK/ACT — When lit, a valid port connection has been made. When blinking,
data is being transmitted or received.
2
English
2
4
6
PoE
PoE
1
3
5
8
10
12
14
16
7
9
11 13
15
English
16-port
™
2
4
1
3