Using The Sparkling Water Dispenser - Samsung RF31FMESBSL Guia De Inicio Rapido

3. Using the Sparkling Water
Dispenser
NOTE
• If you hold down the "Sparkling Water" button for 3 seconds, the cylinder is reset and sparkling
water is immediately produced. In this case, the amount of CO
CO of the sparkling water may be high.
2
• When the sparkling water module is 'off' (the 'off' icon over the sparkling water icon is on), if you
hold down the "Cubed/Crushed" button for 3 seconds, the sparkling water maker immediately
produces sparkling water.
• If you are not planning to use the sparkling water maker for an extended period of time, hold down
the "Cubed/Crushed" button for 3 seconds to turn the sparkling water maker off. Even if you stop
the sparkling water maker, sparkling water will be dispensed as long as sparkling water remains
in the sparkling water tank. (Stopping the sparkling water maker means disabling the automatic
sparkling water production function.)
DA68-02942A-05.indb 4
• If you press the "Water" lever, normal water will be dispensed
regardless of the sparkling water setting.
• If you press the "Ice/Sparkling" lever, sparkling water or ice
will be dispensed depending on the setting. (If you select the
"Sparkling Water" button, the sparkling water icon is displayed
and the previously selected ice icon is turned off.)
• If there is no sparkling water in the sparkling water tank, the
sparkling water maker is operating or the CO
no sparkling water will be dispensed even if you press the lever.
- While producing sparkling water, the numbers next to the
sparkling water icon blink.
• If you use up the CO gas in the cylinder, the density of the CO
2
gas in the produced sparkling water may be very low. In this
case, replace the CO cylinder with a new one. After replacing
2
the CO cylinder, you have to hold down the "Sparkling Water"
2
button for 3 seconds to reset the cylinder in order to start the
sparkling water production.
English - 4
cylinder is empty,
2
gas injection increases and the
2
2
2018. 7. 31. 2:35