WATERLOO HYPER TOUGH Manual De Usuario página 2

HARDWARE
tooLS REQuIRED:
Cross-tip Screwdriver
3/8-in Wrench
7/16-in Wrench
HARDWARE INCLuDED:
26-INCH CABINEt HARDWARE
#14 - 10 x 5/8-in Hex Screws
(Qty: 16)
#14 - 10 x 3/4 Cross-tip Screw
(Qty: 4)
HARDWARE INCLuDED:
40-INCH CABINEt HARDWARE
#14 - 10 x 3/4-in Screws
(Qty: 4)
1/4 - 20 x 5/8 Screw (Qty: 16)
1/4-in Nut (Qty: 16)
NotE: Not all assembly instructions will apply to your model.
SIDE HANDLE AttACHMENt
Items Needed:
#14 - 10 x 3/4 Cross-tip Screw (Qty: 4)
Cross-tip Screwdriver
process:
• Attach the side handle using (4) #14 - 10 x 3/4 Cross-tip
screws.
• Hand tighten. Do not overtighten.
CAStER INStALLAtIoN (26-INCH WIDE CABINEt)
Items Needed:
#14 - 10 x 5/8-in Hex Screws (Qty: 16)
3/8-in Wrench
process:
NotE: use adequate personnel for this operation.
NotE: failure to install caster angles may result in
premature cabinet failure.
• Place the unit on its top. Use packaging material to
protect the paint finish.
• Position caster angles on the cabinet. Flanges should be
toward the inside and pointed up.
• Mount both swivel casters on the same side of the
cabinet as the side handle.
• Attach casters and caster angles using (4) #14 - 10 x 5/8
Hex Screws for each caster.
• Wrench tighten all screws. Do not overtighten.
• Return the unit to its upright position.
Caster angles
(flanges inside)
2
ASSEMBLY