Honeywell 44277 Guia De Inicio Rapido

44277 (2 PACK), 44280 (3 PACK), 44281 (4 PACK)
PRELINKED PLUG-IN
LED LIGHT FIXTURE
SAVE THESE INSTRUCTIONS FOR POSSIBLE FUTURE USE.
IMPORTANT SAFETY INSTRUCTIONS
The LED light fixture has a polarized plug (one blade is wider than the other) as a feature to
reduce the risk of electric shock. This plug fits in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Never use with an extension cord unless plug can be fully inserted. Do not alter the plug. Read
entire installation procedure before you begin.
Under no circumstances should this product be used with a dimming circuit or any other
electronically switched control.
INSTALLATION PROCEDURE FOR PLUG-IN LED LIGHT FIXTURE
Carefully plan your installation prior to mounting the LED light fixture. Making sure that your
5ft. line cord will reach the nearest electrical outlet. For kitchen installations, the recommended
mounting is near the front lip of your kitchen cabinet as shown in Figure 1. This provides the best
light distribution across a countertop.
1. DO NOT ATTEMPT TO INSTALL LED LIGHT FIXTURE
WHILE PLUGGED IN.
2. Select a suitable dry mounting location (indoor only).
Make sure mounting surface is capable of supporting the
LED light fixture.
3. Locate positions where LED light fixture should be mounted.
4. Using a 3/32" drill bit, pre-drill holes into the mounting
surface. Mounting is via keyhole. When inserting the
provided screws, leave 1/8" of the screw heads protruding
beyond the mounting surface.
5. Mount the LED light fixture to surface by aligning screws
to keyholes and sliding into place to secure, as shown in
Figures 2 and 3.
6. Repeat step 5 as needed.
7. Plug LED light fixture into a 120VAC 60Hz outlet.
CLEANING INSTRUCTIONS
Your LED light fixture is made from quality materials that will last
for many years with minimum care. When cleaning, make sure
you have unplugged your LED light fixture and allowed sufficient
time for it to cool to room temperature. You should clean the
housing and lens using a soft, damp cloth. Do not use chemicals
to clean your LED light fixture, as this could result in damage or
discoloration. You should plug your LED light fixture back in only
after it has thoroughly dried.
Questions? Contact our U.S.-based Consumer Care at 1-855-698-8324,
7AM–8PM, M-F, Central Time.
For the most up-to-date product support, accessories, electronic (PDF) format manuals and
more, visit www.byjasco.com/support.
READ IT OR WATCH IT
This device complies with Part 15 of the FCC and Industry Canada license-exempt RSS
standards. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user's
Read instructions or watch easy-to-follow video.
Scan QR code or visit http://bit.ly/2L2RTC0 authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
CAN ICES-3(B)/NMB-3(B)
44277 (2 PACK)
120VAC 60Hz
12.4W
960 Lumens
81 CRI
2700K CCT White
FIGURE 1
CABINET
COUNTER TOP
FIGURE 2
CABINET
FIGURE 3
INSERT
The Honeywell trademark is used under license from Honeywell International Inc.
Honeywell International Inc. makes no representation or warranties with respect to this product.
This product is manufactured by Jasco Products Company LLC.
This Jasco product comes with a limited-lifetime warranty. Visit www.byjasco.com for warranty details.
MADE IN CHINA
SLIDE
©JASCO 2020 | 44277, 44280, 44281 | 02/03/20 v2
Jasco Products Company LLC.
10 E. Memorial Road
Oklahoma City, OK 73114
DO NOT RETURN THIS
STOP
PRODUCT TO THE STORE
FCC/IC - EN
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from which the receiver
is connected.
— Consult the dealer or an experienced radio/TV technician for help.
SPECIFICATIONS
44280 (3 PACK)
120VAC 60Hz
18.6W
1404 Lumens
81 CRI
2700K CCT White
WARNING
RISK OF ELECTRICAL SHOCK
• DO NOT USE IN WET LOCATIONS
• USE INDOORS ONLY
• USE ONLY INSULATED STAPLES OR
PLASTIC TIES TO SECURE THE CORDS
• ROUTE AND SECURE THE CORDS SO
THAT THEY WILL NOT BE PINCHED OR
DAMAGED
NO SERVICEABLE PARTS
NON-REPLACEABLE LEDS
LED LIGHT OUTPUT IS STRONG
ENOUGH TO INJURE HUMAN EYES.
PRECAUTIONS MUST BE TAKEN TO
PREVENT LOOKING DIRECTLY AT THE
LEDS WITH UNAIDED EYES FOR MORE
THAN A FEW SECONDS.
44281 (4 PACK)
120VAC 60Hz
24.8W
1871 Lumens
81 CRI
2700K CCT White
RISK OF FIRE
• NOT INTENDED FOR ILLUMINATION OF
AQUARIUMS
• NOT INTENDED FOR USE ABOVE
STOVES, COOK TOPS, SINKS OR OTHER
HEAT PRODUCING APPLIANCES, SUCH
AS COFFEE MAKERS, TOASTERS, OR
TOASTER OVENS
• NOT INTENDED FOR RECESSED
INSTALLATION IN CEILINGS OR
SOFFITS
• NOT INTENDED FOR SURFACE
INSTALLATION INSIDE OR ON TOP
OF BUILT-IN FURNISHINGS SUCH AS
KITCHEN CABINETS, CHINA CABINETS,
OR TROPHY CASES
• DO NOT CONCEAL POWER SUPPLY
CORD OR LINKING CORDS INSIDE
A WALL, CEILING, SOFFIT, KITCHEN
CABINET, OR SIMILAR PERMANENT
STRUCTURE
• DO NOT RUN THE POWER SUPPLY
CORD OR LINKING CORDS THROUGH
HOLES IN WALLS, CEILINGS OR
FLOORS