Honeywell 50250 Serie Importantes Instrucciones De Seguridad página 4

INTELLI-CHECK
The Intelli-Check Filter Indicators serve as a convenient guideline for when to check/
™
change the HEPA filter and when to replace the odor absorbing pre-filter. Depending upon
your individual usage (environment and hours used), you may need to clean/replace the
filters more or less frequently.
When the HEPA Filter Indicator Light turns on, it's time to check your HEPA filter. The
Intelli-Check reminder for when to check the HEPA filter is intended as a guideline only as
™
the performance of the filter media is dependent on the concentration of the contaminants
to which the system is exposed. On average, for best performance your HEPA filter
will need to be replaced every 3 to 5 years. If there are sources of large amounts of
contaminant generation (such as dust from woodworking or heavy smoking) the HEPA filter
in your air purifier may need to be replaced more often. For instructions on how to replace
your HEPA filter, refer to section "Replacing the HEPA Filter" in this manual.
When your Pre-filter Indicator Light turns on, it's time to replace your odor absorbing pre-
filter. It should be replaced at least every 3 months. If there are heavy concentrations of
odors, smoke, or large particles in the home, you may need to change the odor absorbing
pre-filter more often. For instructions on how to replace your pre-filter, refer to section
"Removing/Changing the Filters" in this manual.
Note: We do not recommend operating the air purifier without the odor absorbing
pre-filter.
Your air purifier was shipped with a carbon zeolite odor reducing pre-filter
replaced with either pre-filter
50255 Line Art
household gas absorption performance. Replacement pre-filters may be purchased at the
retail store where you purchased your air purifier, or can be ordered directly from Kaz USA,
Inc. at www.replacementfilters.com. If you need assistance or have any questions, contact
Kaz Consumer Services at 1-800-477-0457.
RESET FILTER INDICATOR/TURN LIGHT OFF
To Reset Filter Indicator
• Once the filter has been checked and replaced as
needed, the filter indicator will need to be reset.
• With the unit powered on, press and hold the
appropriate filter indicator button down for
approximately 10 seconds until the light turns
off (Fig. 1).
4
50150N_50250S_OM.indd 4
™
FILTER INDICATOR
or . The
Plus Plus
pre-filter features enhanced odor and
Plus Plus
Fig 1
. It can be
11/18/10 4:37 PM