Device Options (Windows Environment) - Kingston DataTraveler 4000 Manual Del Usuario

Tabla de contenido

Idiomas disponibles

Once the DT4000 has been initialised, you can

access the secure data partition and use the

device options by logging in to the device with

your password. To do so, follow these steps:

1. Insert the DT4000 into a USB port on your

notebook or desktop and enter your

password (see

Figure 4.1

• Once you've typed your password,

click the 'Login' button to continue.

• If the correct password is entered, the

DT4000 will unlock and you can begin

using the device.

• If an incorrect password is entered, an error message will appear just below the 'Hint'

field, indicating a login failure.

(NOTE: During the login process, if a bad password is entered, you will be given another

opportunity to enter the correct password; however, there is a built-in security feature that

tracks the number of

10 failed attempts, the DT4000 will lock and require a device format of the secure data partition

prior to its next use. THIS MEANS THAT ALL DATA STORED ON THE DT4000 WILL BE

LOST. For more details on this feature, see 'Device Lockout' on page 24).

2. You may unlock the secure data partition in read-only mode, sometimes referred to as

"write-protect mode", by selecting the checkbox labeled 'Read-Only Mode' prior to logging

into the device. Once authenticated under read-only, you will be allowed to open or view

content on the DT4000, but not update, change or erase content while in this mode. (Note:

Read-only mode will also prevent the format option from appearing in the DT4000 menu

that later appears on page 10).

If you are currently logged in under read-only mode and wish to unlock the device with full

read/write access to the secure data partition, you must shut down the DT4000 (see page 11)

and log back in, leaving the 'Read-Only Mode' checkbox deselected during authentication.

* Once you authenticate to the device successfully, the failed login counter will be reset.