Kingston DataTraveler 4000 Manual Del Usuario página 23

3. To initialise the DT4000, type the following command at the terminal prompt and press
./dt4000_initialize* (Remember, commands are case-sensitive.) See
ENTER:
4. After pressing
ENTER
to accept the licence agreement and continue. (Note: If you press 'N' and do not accept the
licence agreement, you will be returned to the terminal prompt and unable to continue the
initialisation process until you repeat step 3 and press 'Y').
5. After you accept the licence agreement, you will be prompted to input (create) a password,
which will be used to protect the files stored on the secure data partition. The password you
create must meet the following criteria before the initialisation process will allow you to
continue:
a. Passwords must contain 8 characters or more (up to 16 characters)
b. Passwords must contain three (3) of the following:
- UPPER CASE, lower case, numeric and/or special characters (!, $, etc.)
6. Confirm your password by re-entering it on the command line when prompted to input it
again and press
been initialised successfully. If the passwords do not match, you will receive a message
indicating that you still need to confirm the password correctly. To do so, repeat steps 5
and 6 until the passwords match.
After creating your password, a secure data volume (partition) will appear on the desktop. This
indicates that the initialisation process was successful and is now complete. You may begin
using the DT4000.
*Note: Certain distributions of Linux will require super-user (root) privileges in order to execute
the DT4000 commands properly in the terminal application window.
Document No. 48000127-001.A04
Figure 10.4 – Executing a DT4000 command
, the licence agreement will display in the terminal window. Press 'Y'
. If the passwords match, you will be notified that the DT4000 has
ENTER
®
DataTraveler 4000
.
Figure 10.4
Page 22 of 28