Safety Instructions - Klarstein SUMMERSHINE SLIM Manual De Usuario

EN
24

SAFETY INSTRUCTIONS

• Do not use the light shower in damp places.
• Before use, remove all packaging and check the device for damage. If you are
unsure, contact customer service.
• The device may only be used by suitable persons.
• Children should be supervised during use. This light shower is not a toy.
• They do not need special training for this device.
• Keep the power cord away from heat and open fire.
• The minimum distance between the light shower and flammable objects must
be 1 m.
• The operating voltage must correspond to that indicated on the rating plate.
• After use, disconnect the power plug and allow the light shower to cool down.
• Never touch the light shower with wet hands. Keep them away from moisture.
• Protect the light shower from strong impacts.
• Never pull on the power cord, grasp the plug to pull it.
• If the power cord is damaged, it must be replaced immediately by qualified
personnel.
• Never attempt to repair the light shower yourself.
• Disconnecting from the mains can only be done by pulling the mains plug.
Always use an easily accessible power outlet.
• Do not use the device near volatile substances, pure oxygen or nitrous gases.
• The device does not require any adjustment.
• The device has no components that can be repaired or maintained.
• The user must not touch the appliance and the person to be treated at the
same time.
• The device must not be modified.
• In case of health concerns of any kind, consult your family doctor!
Important notes on electromagnetic compatibility (EMC)
• Use of this appliance adjacent to or stacked with other device should be
avoided because it could result in improper operation. If such use is necessary,
this appliance and the other device should be observed to verify that they are
operating normally. If the appliance does not light on or flickering, it means
that the appliance is not operating normally.
• Do not use near active HF surgical equipment and the RF shielded room of
an ME system for magnetic resonance imaging, where the intensity of EM
disturbances is high.
• Do not change any cable without authorization of the manufacturer. Use of
cables other than those specified or provided by the manufacturer of this
appliance could result in increased electromagnetic emissions or decreased
electromagnetic immunity of this appliance and result in improper operation.
• Portable RF communications equipment (including peripherals such as
antenna cables and external antennas) should be used no closer than 30 cm
to any part of this appliance, including power cable. Otherwise, degradation of
the performance of this equipment could result.