Declaration Of Conformity - AVS Electronics SD1 WS Manual Del Usuario

INSTALLATION AND ACQUISITION SENSOR
1. Rotate anticlockwise the cap, to detach it from the base
2. Release the "A" connector that links the cap with the board into the base
A
5. Place the Dip Switch 1 to 5 based on selected addressing
6. Place the Dip Switch 8 in ON
11. Place the cover at the base by aligning the tooth
2
mark . Rotate clockwise until the block
.

DECLARATION OF CONFORMITY

INFORMATION ACCORDING TO DIRECTIVE 1999/5/EC (R&TTE)
The product described in this declaration complies with the essential requirements of the Directive 1999/5/EC
(R&TTE) on low-power radio equipment and on the use of radio electric spectrum frequencies, in compliance with
Recommendation CEPT 70-03.
Brand
Model
Operating frequency
Power supply
Rated voltage
Rated current
European Community Countries where this product will be used:
Date
Risk of explosion if battery is not replaced correctly. Only replace it with a battery of the same type or a
battery equivalent to that recommended by the manufacturer.
Do not open, do not recharge, do not expose to high temperatures or fire.
Do not dispose of spent batteries into the environment, dispose of them at specific collection points.
Keep out of the reach of children.
3. Use the sensor base for set up
the two ceiling mounting holes
4. Drill the holes and fix the base
7. After previously enabled the receiver for the acquisition, hang
up the "A" connector and insert the battery pack
8. Check the effective acquisition and quality of the signal.
9. Release the "A" connector and restore the Dip Switch 8 to OFF
NOTE: Always let the Dip Switches 6 & 7 in position OFF
10. Hang up the "A" connector
1
with the reference
3
on the cap
!WARNING!
- 7 -
1
2
3
AVS ELECTRONICS
SD1 WS
868.350Mhz
Lithium battery
3 V
18 μA at rest
No restrictions in the EU countries
15/01/2016
E
N
G
Battery