Tripp-Lite B127A-1A1-BCBH El Manual Del Propietario página 7

Installation
1. Using a USB 3.0 Type-C cable, connect the USB Type-C
source to the INPUT port on the local transmitter unit.
2. Optional: Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-
CERT or P568-XXX-2A Series cables), connect a local monitor to the
LOCALOUT port on the B127A-1A1-BCBH local transmitter unit.
3. Using Cat6 cable, connect the RJ45 port on the local
transmitter unit to the RJ45 port on the remote receiver unit.
4. Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT
or P568-XXX-2A Series cables), connect the remote receiver
unit's HDMI port to a monitor.
5. Turn the power on to your connected TVs/monitors. The
LOCAL (orange) LED will illuminate to indicate the local port is
connected to a display.
6. Connect the external power supply to the local transmitter unit and
plug it into an available wall outlet or (optional) a Tripp Lite Surge
Protector, Power Distribution Unit (PDU) or Uninterruptible Power
Supply (UPS). The POWER (green) LED on the local transmitter
unit will illuminate to indicate the unit is receiving power from the
external power supply. The POWER (green) LED on the remote
receiver unit will illuminate to indicate the unit is receiving power
from the local transmitter unit through PoC technology.
7. Turn on the power to the USB Type-C source. The OUTPUT
(orange) LED on the local transmitter unit will illuminate to
indicate a signal is received from the source.
8. The (orange) RJ45 LED will illuminate on both the local
transmitter unit and remote receiver unit to indicate a signal is
received from source to display. The screen should now display
on the connected monitor.
-08-367 93-3D19.indb 7 -08-367 93-3D19.indb 7
7
3/3/2021 3:25:48 PM 3/3/2021 3:25:48 PM