Replacement Parts - Guardian Technologies AC4870 Instruciones De Uso Y Cuidado

COMBINATION FILTER
*Filter must be removed from plastic bag before use.
NOTE: Pre/Charcoal Filter is affixed to HEPA Filter with velcro.
Filter Package includes:
1 HEPA Filter
1 Pre/Charcoal Filter
Filter lasts approximately 6-8 months depending on use.
*Filter Replacement Indicator: The HEPA reset light on the control
panel will illuminate indicating that it is time to replace your filter.
Replace the filter according to directions (E-7) then push and hold
Timer Button for 5 seconds to reset filter change indicator.
Depending on usage, filter will last approximately 6 months.
See "Cleaning & Maintaining Filter" (E-9) for proper care of filter.

REPLACEMENT PARTS

UV-C BULB (5W):
FILTER:
Model No. LB4000
B
Filter
Model No.
Check out our
FLT4825
Filter Replacement Program
www.guardiantechnologies.com
IMPORTANT: Use Guardian Technologies GENUINE Replacement Parts only.
To Purchase Contact Customer Service
What is CADR?
CADR stands for "Clean Air Delivery Rate," which indicates the volume of filtered air delivered by
an air purifier. CADR ratings show the effectiveness of how efficient the air purifier is at capturing
fine particles from things like tobacco smoke and plant pollens from the room.
Clean Air Delivery Rate
From air cleaner to air cleaner, compare the CADR numbers. First look at suggested room size.
Then refer to the Clean Air Delivery Rate (CADR) numbers. The higher the number, the faster
the unit filters the air.
Refer to website for individual model CADR numbers.
E-6
Create ONE
COMBINATION FILTER
REPLACEMENT
CARBON FILTER
4-PACK:
Model No.
FLT22CB4
™
OPERATING INSTRUCTIONS
BEFORE OPERATING THE AIR PURIFIER:
1. Carefully remove your air purifier and combination filter from box and bag.
2. Select a firm, level and flat location for the air purifier.
• For proper air flow, locate the unit at least 1 foot from any wall or furniture.
• Make sure none of the grills are blocked.
3. Plug the power cord into a 120V AC outlet.
IMPORTANT: When moving the air purifier, always lift unit by the carrying handle located on the back.
OPERATING THE AIR PURIFIER:
1. Turn unit power ON.
2. Select fan speed MODE 1 - 5
(1 = lowest speed setting; 5 = highest speed setting)
3. Select UV-C ON or OFF using UV-C Power Button.
4. TIMER: If you prefer to run the purifier for a specific number of hours, you can
select between 1 and 8 hours on the display.
INSTALLING/REMOVING COMBINATION FILTER
The HEPA reset light on the control panel will illuminate indicating that it is time to replace your filter..
1. Turn off and unplug the unit.
2. Press the Lock & Release 3. Remove the used
Button and remove the Combination Filter
Rear Cover from the unit. and dispose of it in
the garbage.
5. Reattach the Rear Cover of the unit and securely latch into place.
6. Push and hold Timer Button for 5 seconds to reset filter change indicator.
4. Remove new filter from box
and bag. Insert into the unit.
Consult the arrow on the filter
for correct installation direction.
E-7