Perles OF 9 Instrucciones página 16

softwood
hardwood
Find out the corresponding number of revolutions by a
practical test.
Holding and guiding the tool
Hold the tool with both hands while working. Switch on
the tool only when the router does not touch the surface
of the workpiece.
Before the router reaches the workpiece, the tool should
be switched on.
Do not apply pressure on the tool while working, let the
tool do the work for you.
Do not tilt the tool in order to avoid uneven milling.
Keep the ventilation slots uncovered.
Follow the next order when working with the router:
1. choose abit and clamp it into the collet chuck
2. set the desired depth of milling
3. switch on the tool
4. push the motor downwards, pull the lock lever
5. start milling
6. release lock-off
7. switch off the tool
Circular milling with compasses
Fix the compasses to one of the depth adjusters
fasten the point with a wing nut. Insert the composed
compasess into one of the holes in the baseplate of the
router. Set the desired distance between the router and
the the compasses' point, and fasten it with a wing nut.
Using guide bushing
Guide bushing serves for milling and copying curves. Fix
the chosen gude bushing in the baseplate of the router
from bottom up with the two enclosed screws M5. When
you copy objects be careful that you choose the smallest
difference possible in the outer diameter between the
bushing and the router, for only this way you will get
small difference between the copied curve and the
original one.
Direction of moving the tool
While milling you must pay attention to the right direction
of moving the tool regarding the workpiece.
Move the router in the opposite direction of the bit's
turning (protitek).
Using chip deflector
When milling large depths, we recommend to mill in
stages by small depths odvzemi materiala. Using the
revolverskega nastavka, you can divide milling into two or
three stages.
Set the desired depth of milling to the maximum depth of
milling . Start the first two millings at higher setting
levels.
Fixing points for accessories
There are three threaded holes M6 on the sliding cover
of the router that enable fixing of accessories and the
adapter to the router table.
RECOMMENDATION
Leave all repairs, control and replacement of brushes
to our authorized after-sales service.
MAINTENANCE
Disconnect the plug before any work on the
tool.
Tool needs no additional lubrication.
Keep the tool clean.
Clean ventilation slots regularly.
Do not clean the tool with sharp objects or
household cleaning products that contain petrol,
trichloroethylene
substances damage the plastic parts of the
tool. Clean the surface of the tool with a soft cloth.
Do not expose the tool to moisture.
WASTE DISPOSAL AND
ENVIRONMENT PROTECTION
Take broken tools and accessories to an
authorized service centre, where they have
organized disposal of raw materials for recycling
or suitable destruction.
Disposal of waste packaging, waste electrical
and electronic
according to the regulations on waste treatment.
GENERAL INFORMATION ABOUT
GUARANTEE
Guarantee is offered according to legal provisions that
are valid in individual countries.
Guarantee does not cover:
- Regular maintenance,
- Wear-and-tear
brushes, grease, etc.),
- Enclosed accessories,
- Damages caused by inappropriate use,
- Damages caused by not using original accessories,
- Damages due to normal wear, and
- Damages caused by overloading.
If any repairs are required, take the tool to the nearest
authorized service centre. Do not dissemble the tool by
yourself!
Guarantee terms and the list of service centres are
written on the guarantee card.
16
and ammonia.
equipment is carried
materials (change of
These
out
carbon