Color Mode - Design TRAXON MOOD LIGHT Manual De Utilización & Garantía

B) To Turn The Mood-Light 'object' Power On/Off
Press the ON button on the remote control to turn-on the Mood-Light 'object'. Note: The default start up condition of the
Mood-Light 'object' will be ON when the power is connected for the first time.
After turning the Mood-Light 'object' on, you can choose from the Color Mode, the Sequence Modes, the Function Modes,
or the Pause Mode as described below.
Press the OFF button on the remote control to turn-off the Mood-Light 'object'.
MOOD-LIGHT 'object' FUNCTIONS
A) Color Mode
You can create and save any color on the Mood-Light 'object'.
By changing the intensity of the three primary colors: red, green and blue you can blend unlimited secondary colors.
1) To Create a Color
Press the COLOR (C1) button on the remote control to create any color for the Mood-Light 'object'. The Mood-Light
'object' will blink once in acknowledgement of the remote's command.
Press RED (+) or (-) to increase or decrease the amount of red.
Press GREEN (+) or (-) to increase or decrease the amount of green.
Press BLUE (+) or (-) to increase or decrease the amount of blue.
See Illustration 1 (Color Chart Subtractive), page 24
See Illustration 2 (Color Chart Additive), page 24
Mix Chart: Magenta = mix Blue and Red
Yellow = mix Green and Red
Cyan = mix Green and Blue
White = evenly mix Red, Green and Blue
To return to the default Color Mode at any time, press COLOR (C1) button on the remote control; this will reset any previous
setting you may have made. You can then proceed to create colors as described above.
0 7