Auto Shut Off; Care And Maintenance - Russell Hobbs 25600-56 Manual De Instrucciones

• To refill at any time during use, turn the steamer off by pressing the power button until the blue
indicator light goes out, unplug from outlet, and follow the above procedure.
• After refilling, allow to reheat for 45 seconds and then prime the pump by holding the steam trigger
until steam forms.
USING
• If the label says "do not iron" or shows this icon i, fit the delicate attachment and make sure to test
on an inconspicuous area prior to steaming the entire garment.
• If the label says "do not steam" or shows this icon
1. Hang the garment in an area that will not be affected or damaged by the heat and steam, such as on
a shower curtain rail, or in an open doorway.
2. Fit any attachment you wish to use.
3. Plug the steamer in then press the power button. The blue power button light will slowly flash,
indicating that the steamer is heating.
4. After about 45 seconds the power light will stay on, indicating the steamer is preheated.
5. Prime the water pump by holding steam trigger until steam forms.
6. To generate steam, press the steam trigger. As long as the trigger is held, steam will emit from the
steamer. When the trigger is released, the steam will stop.
7. To generate a constant flow of steam without holding the trigger, press the steam trigger and then
slide the steam trigger lock downwards. You can then release pressure on the steam trigger. To turn
the steam off, press the trigger, slide the steam trigger lock upwards, then release the trigger.
8. With your free hand keep the fabric taut. Steam the garment with slow, downward strokes, keeping
the head of the steamer in contact with the fabric.
9. When you have finished, press and hold the power button until the blue light goes out (about 3
seconds) and unplug.
10. Stand the steamer on its base and allow it to completely cool off before storing. To avoid mineral
buildup, empty the tank after each use.

Auto shut off

Your steamer will automatically switch to auto shut-off mode after being left inactive for 15 minutes. The
power button light will flash rapidly to indicate this. To resume steaming, press the steam trigger or power
button and wait for your steamer to fully reheat.

CARE AND MAINTENANCE

1. Make sure steamer is off, unplugged and completely cool.
2. Wipe all surfaces with a clean damp cloth.
3. After the steamer has been thoroughly dried, turn it back on and lightly steam over an old cloth. This
will help remove any residue left in the steam holes.
4. To avoid mineral buildup, empty the tank after each use.
Cleaning attachments
• Lint attachment: Wipe with damp cloth to clean.
• Delicate fabric attachment: Wash with cold water and small amounts of a gentle cleanser if needed.
The fabric cannot be removed.
• Upholstery attachment: The fabric can be removed and hand washed with cold water and a gentle
cleanser.
, do not steam the garment.
m
5
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
AE