Perel Tools 406 Manual Del Usuario página 2

1. Place the thermostat as following:
a. About 160cm up from the floor on a wall with constant temperature in the house
b. Only on inside walls (not on a wall towards the outside door)
c. Not exposed to direct sunlight
d. Not close to a heater, furnace or ventilation outlet
e. Not close to a door toward the outside door
2. Remove the front cover; unscrew the screw in the battery compartment. Remove the front housing of the base.
3. Unscrew the screw in the protective cover and remove the protective cover.
4. Mount the base on the wall and make sure the hole on the wall is covered by the base with wires coming in
through the protective cover hole.
5. Loosen the screw of the terminal block and install the wires into the terminals
6. Put the protective cover back to the base and lock the cover with the screw.
7. Put the front housing back to the base and lock the front housing with screw.
8. Install 2 x AA-size batteries into the battery compartment.
9. Press the RESET key once and make sure it is working on initial condition.
3. Description
Program setup
Temperature reading
Clock setup
RESET Reset button
Power ON / OFF button
Vacation temperature setup
Enter button
Day temperature
☼
Night temperature
+ Higher temperature
- Lower temperature
4. Operation
Setting the clock
After battery installation (2 x AA size) or pressing RESET or the
mode. The hour is flashing. Set the hour with + or -. Press
adjust the minutes. Press
confirm the setting. The display will return into running mode.
Viewing the programs
The thermostat is a weekly programmable thermostat, 7 days with 24 hours can be set. Each hour can select ☼
(comfort temperature or CT) or
installed. This preset program is set for most families.
Heating and Climate Programming
Press the key. The Monday preset program at 0:00 is being displayed. Press + or -. The display will show the
temperature setting for each hour, e.g. Monday ET program is set at 0:00 - 5:59 and 8:00 - 15:59, CT program is set
at 6:00 - 7:59 and 16:00 - 22:59. Note that the ET is set at 23:00 - 0:00.
Press the key to display the next day preset program. Press + or -. This will show the temperature setting for
each hour. Repeat the above steps, each preset program will display until Sunday. Once the Sunday program has
been reviewed, press the
406
to confirm the setting. The day is flashing. Press + or - to adjust day. Press
(evening temperature or ET) temperature. A weekly factory preset program is
key. The display will return into running mode.
key, the thermostat will enter the time adjustment
to confirm. The minutes are flashing. Press + or - to
2
key to
PEREL