Troubleshooting - Goalzero SLIDE Manual Del Usuario

TROUBLESHOOTING

Q; Can I use the Slide on an iPhone 6 Plus or the Slide Plus on the
iPhone 6?
A: No, the device will not be compatible with a different size
device as it will not fit properly on different sizes of the OtterBox
uniVERSE case. Also, do not use the Slide or Slide Plus with older
versions of the iPhone.
Q: My phone doesn't seem to be accepting a charge from the
Slide. What gives?
A: Try removing the Slide from your device and reset your device by
turning off, then back on. Try the Slide again, the issue should be
resolved. Also, ensure the Slide is fully charged.
Q: My Slide doesn't seem to be taking a charge from my power
source. What could the issue be?
A: Try using a different micro-USB cable, often the issue is tied to
the cable, not the device itself.
Q: Can I use the Slide to recharge other Lightning compatible
devices?
A: No. Using the Slide with incompatible devices can result in
damage.
Q: When I'm charging my device from the Slide my device will
randomly start/stop charging. Why is this happening?
A: Make sure your Slide is pressed firmly into the OtterBox
uniVERSE case making a complete connection. If the Slide is not
fully seated into the case there may be interruptions during charge.
Also, ensure the Slide is completely charged.
5
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.