Steren BOS-660 Manual De Instrucciones página 9

Fig. 3
Coaxial cable
Fig. 4
Use an outdoor matching adapter (adapter not included) to con-
nect the coaxial cable to the antenna. There are two ways to
connect the cable to the pre-amplifi er:
1.- Use other adapter to connect the coaxial cable to the connec-
tors labeled with 300ohms
2.- Remove 6cm of the plastic cover of the cable. Twist the mesh
until you make a tight tip. Then cut 3cm of the isolation of the co-
axial cable, in order to see the central conduit. Place the coaxial
cable under the holder and connect the central conduit under the
left connector and the mesh in the right side (See Fig. 4).
ENGLISH-9