ENGLISH
10
Disassembling and cleaning the juicing unit
1
Remove the pusher from the feeding tube (Fig. 21).
2
Remove the berry tray from the feeding tube (Fig. 22).
3
Turn the juice collector counterclockwise until the arrow ( Á) points to the 'open' indication
and remove it from the juicing unit. (Fig. 23)
4
Remove the two-part filter and disassemble it (Fig. 24).
5
Remove the juicing screw (Fig. 25).
6
Turn the pulp outlet counterclockwise until the arrow ( Á) points to the 'open' indication and
remove it from the juicing unit. (Fig. 26)
7
Rinse all parts under the tap or are also dishwasher-safe. Allow all parts to dry thoroughly
before reassembling the juicer.
This appliance has no other user-serviceable parts. For assistance call 1-866-309-8817.
Storage
1
Wind the power cord around the cord storage wrap in the base of the motor unit (Fig. 27).
2
You can store the pusher, the juice jug and lid, and the berry tray in the pulp container (Fig. 28).
Disposal
-
For disposal or recycling information, please contact your local authorities or visit
www.recycle.philips.com (Fig. 29)
Accessories
Philips accessories may be purchased at a store near you or on our website: www.philips.com/
store.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support
for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem
The appliance does
not work.
The motor unit gives
off an unpleasant smell
the first few times the
appliance is used.
Solution
The appliance is equipped with two safety pins. If either the juicing unit
or the pulp container has not been placed on the motor unit properly,
the appliance does not work. Check whether these parts have been
assembled in the right way (see chapter 'Preparing for use'), but switch
off the appliance before you do so.
This is not unusual. If the appliance continues to give off this smell after a
few times, check the quantities you are processing and the processing
time.