Publicidad
Idiomas disponibles
Idiomas disponibles
3B SCIENTIFIC ® PHYSICS
Relative Pressure Sensor, ±1000 hPa U11323
Instruction sheet
03/08 Hh
1. Safety instructions
•
To avoid permanent damage to the internal
semiconductor
sensor,
permitted relative pressure of 4000 hPa must
never be exceeded.
Only suitable for use with non-corrosive gases such
as air, helium or nitrogen.
•
Do not allow the sensor element to come into
contact with water.
2. Description
Relative pressure sensor with a measurement range
up to 1000 hPa, suitable for measuring the
pressure on the piston of the transparent Stirling
engine U10050 (for a pV diagram).
For two-port measurement using the sensor, hose
connections are provided for two inputs.
The sensor box is designed to be detected
automatically by the 3B NETlog
the
maximum
TM
unit.
3. Equipment supplied
1 Sensor box
1 MiniDIN 8-pin connector cable, 60 cm long
1 Silicone hose, internal diameter 2 mm, 1 m long
4. Technical data
Measurement range:
Sensor type:
Accuracy:
Resolution:
Connections:
•
Cut the silicone hose into sections of the
required length.
•
Using the lengths of hose, make the pressure
connections between the sensor box and the
Stirling engine.
1
± 1000 hPa
Semiconductor sensor
± 1 %
± 100 hPa
2 hose connections,
4.8 mm diameter
5. Instructions
Publicidad
