Getting Acquainted; Battery Charging - SCOLTA ECO RP-102 Manual De Instrucciones

2. GETTING ACQUAINTED

BATTERY CHARGING

The battery is not charged at the factory. You must charge it before using the equipment.
After purchase or for a long time without using (more than 2 months) the battery can not
have its normal capacity when charging. After charging 2-3 times the battery will have its full
capacity.
Plug the charger into an AC outlet. Connect the USB cable to the USB connector of the device.
The [PTT] button will light purple. When the battery is charged, the [PTT] button will turn
blue. If you charge with the equipment stopped (recommended), pressing [PTT] will show the
battery charge level.
NOTE
Do not recharge the battery if it is already fully charged. It could damage it and reduce its life.
It is advisable to charge the battery with the equipment turned off. If the equipment is running
it can interfere with the correct battery charge.
If the usage time of the equipment does not increase with the battery charged, it indicates that
the battery life has expired and you must replace it with a new one.
INSTALL / REMOVE THE BATTERY
To install the battery, fit it at the bottom of the body of the equipment and press on the top.
When the buckle fits you will hear a "click" indicating that the battery has been properly fitted
and secured.
To remove the battery, first turn off the computer. Then press the buckle down and remove the
battery back.
BELT CLIP
The supplied belt clip can be mounted to make it easier to carry.
EARPHONE JACK / PC CONNECTOR
Use the PC programming software to configure the equipment.