Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS–TOPMOUNT
1. Preparing the installation location
If necessary, disconnect the water supply lines
underneath the sink and remove the old sink.
Place the 2-in-1 template (B) on sink installation
location. Using a pencil, mark the correct location
(see insets on page 2) onto the sink.
Using a jigsaw, cut out the location for the sink.
2. Preparing the sink for installation
* Please skip this step unless additional
holes are necessary for your faucet and/or
accessories.
Gently place sink into countertop cut out to
support the outer ledge of your sink. With a
flathead screwdriver and hammer, proceed to
punch out holes.
Finish the hole with a small tungsten rasp and
remove the stickers on the sink for any
pre-marked holes not needed.
Note: A round sticker on the sink indicates
where the knock-out holes have been prepared.
Check that this sticker has not been moved.
Also note that one hole has already been
prepared.
CAUTION
• DO NOT turn the sink over in order to push
out the pre-scored hole on the sink. This will
damage the sink. Punch out the pre-scored
hole as shown.
1
B
2
A
lowes.com/allenandroth
4
INSTALLATION INSTRUCTIONS–TOPMOUNT
3. Installing the mounting clips (AA)
Turn the sink over and press the mounting clips
(AA) into the pre-drilled holes along the rim of
the sink (A) until they are flush on the base of
the sink (A).
Hammer in the spreader bolts on both sides of
the mounting clips (AA) as far as the stop, using
either a screwdriver or hammer.
Apply silicone sealant (not included) along the
edge of the sink (A).
Installing the mounting clips (AB)
Turn the sink over and press the mounting clips
(BB) into the slotted bracket until fully inserted
(hammer lightly if needed).
Apply silicone sealant (not included) along the
edge of the sink (A)
Hardware Used
Topmount Clip
AA
with Screw
Topmount Clip
AB
with Screw
4. Installing the sink
Place the sink (A) into the countertop and
remove any excess sealant that comes out from
the edges.
Tighten the screws on the mounting clips (AA)
underneath the sink to anchor the sink (A).
3
3
AA
AA
A
A
AB
A
4
x 8
A
x 8
A
lowes.com/allenandroth
5
AA
2
Publicidad
