Allen + Roth JJ-LARGE SB GNT COMP Single Bow Manual De Instalación página 4

INSTALLATION INSTRUCTIONS–UNDERMOUNT
1. Preparing the installation location
If necessary, disconnect the water supply lines
underneath the sink and remove the old sink.
Using a pencil mark the measurements (from the
insets on page 2) onto the sink location.
Using a jigsaw, cut out the location for the sink.
2. Preparing to mount the sink
From underneath the countertop, prepare
30 mm holes around the perimeter of the
installation location. A typical installation will
have two holes at each corner of the sink.
Place the threaded nuts (DD) securely into each
of the holes underneath the counter.
Hardware Used
DD Threaded Nut
1
2
x 8
DD
lowes.com/allenandroth
6
INSTALLATION INSTRUCTIONS–UNDERMOUNT
3. Mounting the sink
From underneath the countertop, apply silicone
sealant around the perimeter of the installation
location.
Place the sink (A) underneath the countertop
by inserting mounting screws (BB) through the
mounting brackets (CC) and into the installed
threaded nuts (DD).
Tighten the screws in a crisscross pattern
to ensure that the sink is installed evenly
underneath the counter.
Hardware Used
Mounting
BB
Screw
Hardware Used
Mounting
CC
Bracket
3
A
x 8
BB
x 8
lowes.com/allenandroth
7
AA
2
CC