Tripp-Lite ENBRKT Guia De Instalacion página 3

Installation
• Installers are responsible for providing wall-mounting hardware. Use a minimum of two 1/4-20 or larger screws (not included) to secure
the mount in place.
• Make sure that mounting screws are anchored into the center of the studs. Use of a stud finder is highly recommended.
• If there is no stud at the mounting location, it is recommended that you use anchors to secure the mount in place. Due to the weight
of the mount, plastic expansion wall anchors are not recommended for drywall installations. Suitable anchors include: threaded drywall
anchors, threaded drywall toggles, sleeve-type hollow wall anchors (a.k.a. molly bolts) or toggle bolts.
2. Run Data and Power Cable (If Required) Through the Mount's Rear Cutout
3. Using the Provided Screws, Attach the Access Point to the Mount
3a. Cisco Low-Profile Bracket
(AIR-AP-BRACKET-1)* Installation
* Cisco brackets not included.
17-12-051-9337E0.indb 3
3b. Cisco Universal Bracket
(AIR-AP-BRACKET-2)* Installation
3
IMPORTANT!
Attach all data and power cables to
the access point prior to attaching to
the mount.
AIR-AP-BRACKET-2
Security Tab
Access Point
Security Tab
Zip Tie
(Included)
3/9/2018 9:19:53 AM